www.kp44.org
— The official website of the Peterson Cutter Owner's Group
Set Site Preferences
Peterson Cutter Group Mast Pulpit Page
The Group Buy for mast pulpits was done in 2006. Contact regarding individual construction.
FINAL DESIGN
Symmetric 3-legged unit with narrow stance for our narrow cabin top
Welded pins for lines are available an option
Stainless plate for lines are an option
Clearance for rigid vang
Welded bails to fasten tethers, snap shackles, barber haulers, and snatch blocks.
Third leg acts as step. Owner can bolt a wooden step across the brace and leg.
Integral 3/8-16 welded nut
Supplied with six 3/8-16 X 3" 304 Stainless THREADED RODS.
Also available are six 2" x 1/16" EPDM U/V resistant rubber washers to use instead of bedding as supplies last (only available for 10 units).
See Design Page
